2WCOM NC06
This connector allows you to monitor and configure the device 2WCOM NC06 via SNMP.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
| 1.0.1.x | DVE support | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
| 1.0.1.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | No | - | 2WCOM NC06 - Device |
| 1.0.1.x | No | No | - | 2WCOM NC06 - Device |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The IP port of the device.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element consists of the following data pages:
- General: Displays general parameters like Description and Uptime.
- Input: Contains a table with the input of the device.
- Output: Contains a table with the output of the device.
- Device: Allows you to add and remove devices connected to this device. When you add a device, go to the Input and/or Output page and select the input/outputs that belong to that device.