2WCOM S02
The 2WCOM S02 contains two independently selectable limiters: a peak deviation limiter and a modulation limiter.
- The peak deviation limiter makes it possible to raise the main volume of the sound file considerably without causing clipping or distortion, while at the same time complying with regulatory demands.
- The optional modulation monitoring checks the audio inputs and notifies the user of low audio level. The modulation monitoring can also be configured to switch automatically between the audio inputs.
About
This connector provides an overview of the states of the AES inputs, the presets and the event settings.
The information is retrieved from the device using SNMP.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | - |
Installation and configuration
Creation
SNMP Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
This page displays the AES Inputs Table, along with the Input, MPX Output, Peak Deviation and Modulation Power parameters.
The page contains page buttons to the following subpages:
- S02 Configuration: Allows you to configure the Language, Preset, Unit and Sensitivity of the device.
- Network Configuration: Allows you to configure network settings such as the IP Address, Subnet Mask, Gateway, HTTP Port, and SNMP trap destination addresses.
Preset
This page displays the Presets Table.
Event Setting
This page displays the Event Settings Table.