ABB Satt Control COMLI-LINK Generator

This connector makes it possible to monitor and gather information from an ABB Satt Control COMLI-LINK Generator controller.

About

This connector is automatically generated by connector ABB Satt Control COMLI-LINK range 1.0.0.X.

The connector only controls aspects related to the ABB Satt Control COMLI-LINK Generator.

All registers are categorized in the following tables:

Inputs table: all addresses where object type is "A_ALARM", "A_ALARMER", "ALARMER", "ANTPOS", "APTAL", "ANNSIGNAL", "MPG", "PROPAL", "RDS", "SAT" or "VVS" and all of the remaining addresses except for the ones from the Commands table.
Commands table: addresses where signal is "MANOVER" or starts with "K_".

This connector is used by DVEs that are automatically created by the parent element. No user input is required.

This page provides a table with the current settings defined at the ABB Satt COMLI-Link Generator.

This page provides a table with the results of each command address. The value column in this table is writable. Commands can be sent to the device.