ADB 3000
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
| 2.1.0.X | Included all buttons, Removed responses of debug, Preset List as dynamic table, Removed automatic data conversion from fixed to dynamic table, Added R/W URL parameter, Added virtual R/W parameters for connections with Philips 3G, Philips 3G parameters set after setting | - | - |
| 2.1.1.X | Added "Profiles" table based on an SNMP Connection | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | N/A |
| 2.1.0.X | N/A |
| 2.1.1.X | N/A |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 2.1.0.X | No | Yes | - | - |
| 2.1.1.X | No | Yes | - | - |
Configuration
Connections
Modbus Communication
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device (default: disabled).
SNMP Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- SNMP Type: Device supports SNMPv2.
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device (default: disabled).
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The Sencore OmniHub has a limited SNMP feature set. Parameters are limited to status and configuration parameters defined in a limited MIB, and SNMP traps are not supported at this time.
Each page contains information related to the OmniHub device such as the IP inputs and outputs, which can be configured in the associated Settings table.