AJA IPR-10G2-HDMI
This connector allows you to monitor and control the IPR-10G2-HDMI mini-converter. This device is designed to bridge SMPTE ST 2110 networks to HDMI, with support up to Ultra HD 50p or HD 60p. IPR-10G2-HDMI receives SMPTE ST 2110 audio and video over 10 GigE, and then de-encapsulate the data to output baseband HDMI video. Associated audio from the SMPTE ST 2110 stream is likewise extracted, synchronized, and embedded into the HDMI output.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
| 1.0.1.x [SLC Main] | Major range introduction to fix parameter types, descriptions, major validator remarks, etc. | 1.0.0.2 | Changes to PIDs/parameter types. Changes to saved parameters/primary keys. Changes to parameter descriptions and discrete display values. |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 2.7.x |
| 1.0.1.x | 2.7.x |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 1.0.1.x | No | Yes | - | - |
Configuration
Connections
HTTP Connection
This connector uses an HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP of the destination.
- IP port: The IP port of the destination (default: 80).
Initialization
If the web API is secured with authentication, make sure the username and password are correctly filled in (via General > Authentication).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to Use
On the Authentication subpage of the General page, you can configure the username and password to access the device.
The Boot Info page contains all information about the booting of the device.
The Audio and Video page contain all information about the conversion from SMPTE ST S2110 to HDMI.