APC AP7724
The APC AP7724 is a rack-mount automatic transfer switch.
About
With this connector, it is possible to monitor and configure APC AP7724 devices.
The different parameters of the device are logically distributed over multiple pages.
Installation and configuration
Creation
This connector retrieves information from the device via SNMP. When you create an element, the following information must be provided:
SNMP Connection:
- IP address/host: The polling IP of the device, e.g., 10.11.12.13.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string needed to read from the device. The default value is public.
- Set community string: The community string needed to set to the device. The default value is private.
Usage
Overview Page
This page displays general information, such as:
- Load status
- Software Version
- Serial Number
- Device Uptime
- Device Ratings
ATS Status Page
This page displays all the statuses of the automatic transfer switch, such as:
- Communication status
- Selected Source
- Source A/B status
- Voltage/Current status
- 5/12/24V Power Supply status
Configuration Page
This page allows the user to change settings on the device, such as:
- Voltage Sensitivity
- Current Limit
- Preferred Source
- Front Panel Lockout
Input/Output Status Page
This page displays the Input Sources and the Output Banks with their load.
Calibration Page
This page displays the Input Phase Calibration Factor and the Power Supply Calibration Factors.