APC PDPM227H
This connector can be used to monitor the APC Modular Remote Power Panel solution. It uses SNMP to retrieve data from the device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 3.6.1 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to Use
The element consists of the pages detailed below.
General
This page displays general information regarding the monitored system. It also contains a table with information about the modular distribution metering equipment.
Modules
This page displays the following tables:
- Module Info Table: basic information about the distribution modules installed in the system.
- Module Breaker Table: operational information about the distribution modules.
- Module Output Table: information and settings related to the load equipment fed by the distribution modules.
System Voltage
This page displays general information about the system voltage and allows you to set voltage and alarm thresholds.
It also contains a table with more information about the system output voltage.
System Current
This page displays general information about the system current and allows you to set current and alarm thresholds.
It also contains a table that displays the total system phase current information.
System Power
This page displays general information about the system power. It also allows you to reset the total kWh usage shown.
The page also a table that displays the total system phase power information.
PDU
This page displays general information regarding the modular PDU.
Environmental Monitor
This page displays information regarding the integrated environmental monitor.
Local Display
This page displays information regarding the local display. It also allows you to configure parameters such as the Beeper Volume, the Key Click, the Contrast of the local display, etc.
Config Traps
This page displays a table listing the trap receivers.