APC Smart-UPS
Smart-UPS devices provide high density, true double-conversion on-line power protection for servers, voice/data networks, medical labs and light industrial applications. Capable of supporting loads from 1 to 20kVA in a rack/tower convertible form, the Smart-UPS On-Line is available from 2U to 12U. All models 5kVA and above include an integrated Network Management Card for remote management (optional on models below 5 kVA). The Smart-UPS On-Line family provides customers with a reliable source of uninterruptible power even in demanding power environments, including very wide input voltage windows, extremely tight output voltage regulation, frequency regulation, internal bypass, and input power factor correction.
About
This connector can be used with all APC Smart-UPS models. It makes it possible to monitor the state of the battery, power status and alarms, as well as to configure different parameters and functionalities. The different parameters from the device are displayed on multiple pages grouped by function.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version. Added traps. | No | No |
| 1.0.2.x | Obsolete. | No | No |
| 1.0.3.x [SLC Main] | Battery Packs table now correctly processes statuses. | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | UPS 07.4 (ID1003) |
| 1.0.2.x | UPS 07.4 (ID1003) |
| 1.0.3.x | UPS 07.4 (ID1003) |
Configuration
Connections
SNMP Connection - Main
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. The default value is public.
- Set community string: The community string used when setting values on the device. The default value is private.
Usage
Once created, the element can be used immediately. The connector has 8 pages, plus a page with the web interface.
General
This page contains general information such as software versions, diagnostics, serial number and model of the device.
Battery Status
On this page, it is possible to check different parameters related to the operational state of the battery as well as the information concerning battery packs.
Note
In range 1.0.3.x, the "Status" column of the Battery Packs table is replaced with different columns that better represent the status of each battery pack entry. The processing of the "Health" status column is also fixed in this range.
Power Status
This page displays electrical information from the UPS input and output
Configuration
This is the main page for the configuration of the device. Here, you can set the Rated Output Voltage, High and Low Transfer Voltages, and Return delay from battery, as well as other miscellaneous settings. The page also provides access to Management, Control, Test, and Sync Control settings.
Alarms
This page displays all the available alarms reported by the device.
Traps
This page displays the Traps table as well as the Total Traps parameter and the following buttons
Refresh Table: Refreshes the number of total traps, and deletes traps if total number exceeds Max Traps, or age exceeds Max Age
Clean Up Config: Opens a subpage that contains Trap Clean Up Method, Max Traps, Max Age Traps, and Trap Clean Up Amount
Outlet Groups
On this page, you can get the status of the outlet groups and configure them.
Diagnostics
On this page, you can diagnose the operation of the device. It includes diagnostics for the Batteries, the Interfaces card, the Power Supply system, etc.
Environmental Monitor
From this page, you can get the list of probes supported by the Environmental Monitor and their configurations. The page also displays the list of contacts.
Web Interface
This page displays the web interface of the device.