Advantech ADAM6060
This device can monitor and control 6 digital inputs and 6 digital outputs through a serial TCP/IP connection.
About
This connector displays information on the 6 digital inputs and 6 digital outputs. The information is requested using the Modbus protocol.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.1.0.x | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.1.0.x | Unknown |
Installation and configuration
Creation
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- Direct connection:
- Baudrate: Baudrate specified in the manual of the device.
- Databits: Databits specified in the manual of the device.
- Stopbits: Stopbits specified in the manual of the device.
- Parity: Parity specified in the manual of the device.
- FlowControl: FlowControl specified in the manual of the device.
- Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device. (Default: false)
Usage
Main View
This page displays the following information for the 6 inputs and 6 outputs: Real state, User value and Inversion mode.
General
This page provides the same information as the Main View page, but also allows you to edit the User value for outputs and the Inversion mode for both inputs and outputs.