Advantech ADAM6251
This connector is a serial connector that controls the Digital Input device.
You can configure the inputs and the streams from the device.
About
The connector communicates through a serial connection with the device to change its configuration and to monitor its inputs and streams.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial Version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | A1.05.B00 |
Configuration
Connections
Serial Main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: 1025
- Bus address: 01
Usage
General
Here you can find the device name and the firmware version.
DI Status
On this page you can find the statuses of the 16 inputs.
DI Configuration
Here you can configure the inputs, you can choose what function they are used for and a few more options.
you can change multiple inputs at once and press save changes, only after you click on save changes will the changes be done on the device.
Stream
On this page you can change the IP addresses of the stream, on the right side you can enable/disable each stream.
Flags
you can configure the GCL flags on this page, at the bottom are 2 buttons that change all of them.
Web Interface
The client machine has to be able to access the device. If not, it won't be possible to open the web interface.