Table of Contents

Advantech AMT 2200K

The AMT 2200K is an Advantech Solid State Power Amplifier (SSPAs), from the range from UHF to Ka Bands.

About

This connector is intended to get information from and set information to the device through an element in a DataMiner System, using SNMP commands.

To get more detailed information on the device, consult the website http://www.advantechwireless.com/

Installation and configuration

Creation

SNMP CONNECTION:

  • IP address/host: The polling IP of the device, e.g., 10.11.12.13.
  • Device address: Not used.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string in order to read from the device. The default value is public.
  • Set community string: The community string in order to set to the device. The default value is private.

Usage

General

On this page, you can find information about:

  • the device, with the Product Information page button.
  • the interfaces of the device, in the Interface Type and Interface Tables.

There is also an option to Reset Device, choosing one of the options available in the dropbox.

Control Panel

On this page, you can find all relevant Control Panel Configurations and Statuses:

  • Control Panel Identification Table
  • Control Panel Configuration Table
  • Control Panel Status Table
  • Control Panel Alarms Table

Transceiver

On this page, you can find all relevant Transceiver Configurations and Statuses:

  • Transceiver Identification Table
  • Transceiver Configuration Table
  • Transceiver Status Table
  • Transceiver Alarms Table

SSPA Ident / Conf

On this page, you can find the SSPA Identification and SSPA Config Tables. Use the SSPA Config Table to set the configurations.

SSPA Status / Alarms

Use this page to have access to the SSPA Status and Alarm Tables.

Alarm Configuration

On this page, you can set the alarm configurations using the Alarm Config Table. The Alarms Group Config and Combined Alarm Module View Tables cannot be edited.

Traps

On this page, traps sent from the device are shown, if the option is enabled in the Alarm Config Table.

Web Interface

This page provides access the device's web interface.

Improve this page