Agilent N9010A-526 EXA
The Agilent N9010A-526 EXA is a spectrum analyzer device.
This connector interfaces with the spectrum analyzer and allows you to monitor the spectrum of any connected signal.
About
Version Info
| Range | Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version (serial connector). | - | - |
| 1.1.0.x | Version based on the VISA library. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | C.04.56 |
| 1.1.0.x | C.04.56 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
| 1.1.0.x | No | Yes | - | - |
Configuration
Connections
Serial Connection — Main — 1.0.0.x only
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
Virtual Connection — Main — 1.1.0.x only
This connector uses a virtual connection and does not require any input during element creation.
Initialization
No initialization is needed for range 1.0.0.x.
For the 1.1.0.x range, several things are needed:
Make sure the VISA library is installed on the DataMiner Agent.
You can download the installer for the library from the Rohde-Schwarz website.
Make sure the DLL RsInstrument.dll is present in the ProtocolScripts folder.
Set the IP address of the device on the General page of the element.
How to use
You can observe the spectrum on the Spectrum Analyzer page.