Agilent N9320B
The Agilent N9320B is a spectrum analyzer that can go up to 3 GHz.
About
The Agilent N9320B connector interfaces with the spectrum analyzer of the same name, and allows the user to monitor the spectrum of any signal connected to the spectrum analyzer. In addition, the connector allows for basic configuration of the device.
Ranges of the connector
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | No |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
Installation and configuration
Creation
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device, by default 5025.
- Bus address: The bus address of the device. This can be any number from 0 to 32.
Usage
General
This page contains basic device information such as the Manufacturer, Model, Serial Number and Firmware Version of the device. It also contains two toggle buttons: Display Status and DMS Spectrum Measurements.
In version 1.0.0.2, an additional toggle button VGA Output Status is included.
Spectrum Analyzer
This page contains DataMiner's default Spectrum Analysis component. In addition to the default functionalities available in all spectrum analyzer elements, it allows you to configure the following parameters:
- Reference Level
- Reference Scale
- Start & Stop Frequency
- Frequency Span
- Center Frequency
- Resolution Bandwidth
- Video Bandwidth
- Sweep Time
- Input Attenuation