Agilis AUC28
The AUC28 wideband series converter is an RF indoor subsystem that provides frequency conversion of 70 MHz/140 MHz (±18 MHz) or 140 MHz (±36 MHz) IF signals to L-Band signals (950 – 2150 MHz or 950 – 1850 MHz) on the transmit side and conversion of L-Band signals (950 – 2150 MHz or 950 – 1850 MHz) to 70 MHz/140 MHz (±18 MHz) or 140 MHz (±36 MHz) IF signals on the receive side.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device, in this case 9600.
- Databits: Databits specified in the manual of the device, default value 8.
- Stopbits: Stopbits specified in the manual of the device, default value 1.
- Parity: Parity specified in the manual of the device, default value No.
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device.
How to use
The element has several pages where you can monitor or configure the parameters of the device:
The General page contains information about AUC, BUC, Alarms, and other general parameters related to the device.
The Voltage and Temperature page contains information about the current voltage and temperature of output and SSPA. You can set the SSPA temperature here.
The Equipment Status page shows all information available on the equipment.
The Frequency and Attenuation page contains current information on temperature and attenuation and allows you to set the uplink and downlink frequency and attenuation.