Apantac LE-20HD
The Apantac LE-20HD is an SDI & composite video input multiviewer with built-in CATx extender.
This connector uses SNMP to poll data from the Apantac LE-20HD device based on the Apantac MIB.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | K(20190808) - Q0(20200325) Q1(20200325) Q2(20200325) Q3(20200325) Q4(20200325) |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
SNMP Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
How to use
On the General page, the Managed Elements Table contains general information and settings, while the Managed Elements Status Table contains status information for each managed element. The Signal Table lists all tracked signals. Each row of this table corresponds with a single monitored signal, e.g. an SDI video feed or an AES/EBU audio feed. For each signal, more information is available, including several status parameters.
On the Configuration subpage, several settings can be configured, including Screens, Monitors, Text Message and Scroll Rate.
This connector can also receive traps available in the Apantac MIB. When a specific trap is received, the relevant table is polled.