Aperi 4K Tico Codec
This is an HTTP connector that is used to monitor and configure the Aperi 4K Tico Codec equipment.
About
The information on tables and parameters is retrieved via HTTP communication.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version. | No | Yes |
| 1.0.1.x [SLC Main] | Streamlined all Aperi connectors. | No | Yes |
| 1.1.0.x | New firmware version. | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
| 1.0.1.x | Unknown |
| 1.1.0.x | 1.1.2 |
Installation and configuration
Creation
HTTP Main Connection
This connector uses an HTTP connection and requires the following input during element creation:
HTTP CONNECTION:
- IP address/host: The polling IP of the device.
- IP port: The microserver slot ID (range: 1 - 5).
Configuration
After element creation, specify a valid User Name and Password to start polling data from the device. To do so, go to the Security Settings subpage of the General page.
Usage
General
This page allows you to monitor the general device parameters.
- The System Information section contains information about the system parameters and the main board specifications.
- The System Utilization section contains the status of the internal parameters, such as temperature, memory and other system parameters.
Via the Security Settings page button, you can configure the username and password to communicate with the device:
- This subpage also displays the HTTP Status Code, which provides information about the HTTP response status of each command, the Application Boot Status and the Login Status, which displays the authentication status. If the Login Status is Not Authorized, the username/password combination is incorrect.
- The Login button verifies the username/password combination and authenticates the user.
Via the Messanine Board Info page button, you can monitor the status of the Messanine board specifications.
Video
This page displays all video interface error info in the Video Input and Video Output tables.
Audio
This page displays all channel and audio group statuses in the Audio Input and Audio Output tables.
SFPs
This page contains information about the installation status of SFPs in the 4 channels.
IP Flows
This page displays the IP flow out information. You can find all channel information in the IP Flow Out Channels table and all port information in the IP Flow Out Management table.
Ethernet
This page displays the status of the Ethernet ports 0 and 1 in the Ethernet table.
Web Interface
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.