Arqiva Radio Trap Receiver
The Arqiva Radio Trap Receiver is used to capture and display the Arqiva Radio alarm traps for the related IP address.
About
The Arqiva Radio Trap Receiver connector captures the SNMP alarm traps from the Arqiva Radio device and displays them in the Alarm Trap Table, in order to visualize the current active alarms.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Installation and configuration
Creation
SNMP connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g., 10.150.3.3.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device. The default value is public.
- Set community string: The community string used when setting values on the device. The default value is private.
Usage
General
This page contains the Alarm Traps table, which displays all alarms that came in through traps. The ID, Timestamp, Source IP, OID, Radio link, Alarm condition, Alarm state and ECAM cct number of the trap are displayed in the different columns.
With the Clear Table button above the table, you can delete all rows from the table.