Arris CHP Max5000 - CHP-D2RRX-85-XQ-S

The CHP-D2RRX-85-XQ-S dual digital return path receiver module contains two independent receiver circuits in a single slot CHP module, enabling up to 20 receivers, or 40 RF streams in a fully-loaded CHP chassis.

About

This connector uses SNMP polling to communicate with the device.

Product Info

Range	Supported Firmware Version
1.0.0.x	1.0.6.0

Installation and configuration

Creation

This connector is used by DVE child elements that are automatically created by the connector Arris CHP Max5000, from version 1.0.0.7 onwards.

Usage

General

This page contains card-specific hardware information and configuration options.

Status

This page displays the generic status of the card, which includes slot information, up time and alarming.

Rx Information

This page displays the Rx Channel Control Table, which contains the RF Status, Low Level, Status, Maintenance Mode and Attenuation Level for each Rx Channel.

Configuration

This page provides access to generic configuration and actions, such as the Module Reset, Factory Default reset and Slot Reset for the relevant card. You can also change the status of the Front Panel Lock, and Blink the card's front status LED.

From version 1.0.0.3 onwards, you can also change some system configuration settings, specifically Date/Time and Alarm Detection, and make a Software Reset.

From version 1.0.0.7 onwards, the license information is also displayed on this page.

Alarm Configuration

This page displays the different alarms that can be configured on this card.

Optical Properties

This page contains information related to the inputs of the device, and allows you to configure the Wavelength (1310 or 1550) .