Ateme DR8400
This SNMP connector can be used to monitor and control the Ateme DR8400. Alarm monitoring and trending can be enabled on many important parameters. The connector communicates with the Ateme DR8400 decoder using SNMP.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version. | - | - |
| 1.0.1.x | New firmware version 2.0.0.x | - | - |
| 1.1.0.x [SLC Main] | New firmware version. | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1.1.0.2/1.0.0.4(@162938) |
| 1.0.1.x | 2.0.0.x |
| 1.1.0.x | N/A |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.1.0.x | No | No | - | - |
Configuration
Connections
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
SNMP Settings:
- Get community string: The community string used when reading values from the device (default: public).
- Set community string: The community string used when setting values on the device (default: private).
Web Interface
The web interface is only accessible when the client machine has network access to the product.
How to use
The element created with this connector consists of the following data pages:
- General: Displays general information about the device, such as the Software Version, Temperature, Power Supply Status, etc.
- Input: Displays the input values for Satellite, IP and ASI. Via page buttons, you can configure parameters related to IP, SMM and Failover.
- Decoder: Displays decoding settings. The Services page button displays all incoming services. Several other page buttons are available that open subpages with CA (Conditional Access), Data, Audio, and Video settings.
- Video/Audio Output: Allows you to configure audio and video output settings, so that you can define what the output should look like. Several page buttons are available that open subpages with additional settings: Emulation, Downscale, Mapping, IP Output, Forward, and Genlock.
- Configuration: Contains a table listing configurations. In addition, Management Load and Management Store controls are available.