Aurora Network Node NC 4000 Single DT REV A
The Aurora Network Node NC4000 Single DT REV A connector is a DVE created by the Aurora Network CX3001 connector.
It is created for every Digital Transceiver Module Revision A Type that is part of the NC 4000 chassis. The types that are defined as Type A are:
- DT4032N
- DT4032S
- DT4232N
- DT4250N
About
The information displayed in the main element is delivered in four pages:
- The General page contains a list of the nodes currently used by that transceiver, as well as some general information about this particular module.
- The Transceiver page contains information regarding the status and primary channel of the transceiver module.
- The Node Monitor page contains information regarding the power supplies and power supplies alarm monitoring of the device.
- The Converters page contains information related to the Slot D Converters and Slot E Converters.
Installation and configuration
Creation
This connector is automatically created by the Aurora CX3001 connector. For each digital transceiver found in the system, a virtual element will be created.
Usage
General Page
This page contains information related to the device's node. There is also a Normalize button. When this button is clicked, the current values of the parameters listed below are saved in the Normalized Alarms Table and used for absolute alarm monitoring. The parameters that can be normalized are the following:
- Transceiver RX Optical Power
- Transceiver TX Optical Power
- Receiver B Optical Power
- Receiver C Optical Power
- Receiver D Optical Power
- Receiver E Optical Power
- Node Chain Number
- Slot D DX Input
- Slot D DX Output
- Slot E DX Input
- Slot E DX Output
Transceiver Page
This page displays information related to the Status and the Primary Channel. It also contains SFP/SFF information.
Node Monitor Page
This page contains information regarding voltages, power and currents.
Converters Page
This page displays information related to the Slot D Converters and Slot E Converters.