Axon ACP - GNS600
The GNS600 is a 3G, HD and SD SDI SCTE104 inserter with SDI inputs and outputs. SCTE104 information present in the SDI signal can be transcoded and inserted into the main 3G, HD or SD SDI signal. The GNS600 can insert data from both the Ethernet and SDI domain into lines in the SDI domain or insert a user-defined cue on a preset base.
The Axon ACP - GNS600 connector can be used to display and configure information related to this device.
About
This connector is automatically generated by the connector Axon ACP.
There are different possibilities available for alarm monitoring and trending.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.3.x | Initial version | Yes | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.3.x | 1407 |
Installation and configuration
Creation
This element is automatically created by the parent element using the Axon ACP connector.
Usage
This element has the following pages:
- General: This page displays general information about the card: Card Name, Card Description, SW Revision, HW Revision, etc.
- Status
- Video Status
- S2010 Status
- SCTE104 Status
- S2016 Status
- S2031-OP47-WST Status
- GPI Mode Status
- Video
- Delay
- S2010
- SCTE104
- S2016
- S2031-OP47-WST
- GPI Mode
- Teletext
- X31
- Network
- Network Status
- Alarm Priority: This page displays the event messages of the card, i.e., special messages generated asynchronously on the card.
DataMiner Connectivity Framework
The Axon ACP connector supports the usage of DCF.
DCF can also be implemented through the DataMiner DCF user interface and through DataMiner third-party connectors (for instance a manager).
Connectivity for this protocol is managed by the parent protocol Axon ACP.
Interfaces
Physical Interfaces
- SDI Input 1: A single fixed interface of type input.
- SDI Input 2: A single fixed interface of type input.
- SDI Input 3: A single fixed interface of type input.
- SDI Input 4: A single fixed interface of type input.
- SDI Output 1: A single fixed interface of type output.
- SDI Output 2: A single fixed interface of type output.
- SDI Output 3: A single fixed interface of type output.
- SDI Output 4: A single fixed interface of type output.
Virtual Interfaces
- Internal Switch: A single fixed interface of type inout.
Connections
Internal Connections
When a DVE child element is created, the following connections are established:
- Between Internal Switch and SDI Output 1.
- Between Internal Switch and SDI Output 2
- Between Internal Switch and SDI Output 3.
- Between Internal Switch and SDI Output 4.
Depending on the state of the Input Select, the following connections are established:
- SDI-1: Between SDI Input 1 and Internal Switch.
- SDI-2: Between SDI Input 2 and Internal Switch.
- SDI-3: Between SDI Input 3 and Internal Switch.
- SDI-4: Between SDI Input 4 and Internal Switch.