Table of Contents

Axon ACP 2HS10

The 2HS10 is a dual channel ultra high-quality down converter.

The Axon ACP 2HS10 connector is used to configure and monitor the 2HS10 card.

About

Version Info

Range Key Features Based on System Impact
1.0.0.x [SLC Main] Initial version - -

Product Info

Range Supported Firmware
1.0.0.x 3130

System Info

Range DCF Integration Cassandra Compliant Linked Components Exported Components
1.0.0.x Yes Yes - -

Configuration

Connections

Serial Main Connection

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

Interface connection:

  • IP address/host: The polling IP or URL of the destination.
  • IP port: The IP port of the destination (fixed value: 2071).
  • Bus address: The bus address or slot number/position of the card in the frame.

Serial Broadcast Connection

This connector uses a smart-serial connection and requires the following input during element creation:

SMART SERIAL CONNECTION:

Interface connection:

  • IP address/host: The polling IP or URL of the destination. Specify "any".
  • IP port: The IP port of the destination (fixed value: 2071).
  • Bus address: The bus address of the device.

How to use

The element has the following pages:

  • General: Displays information about the identity of the card and other general information: Card Name, Card Description, SW Revision, HW Revision, etc.
  • I/O: Contains the input and output settings and status information.
  • Down Converter A: Contains down conversion setting parameters of Channel A.
  • Down Converter B: Contains down conversion setting parameters of Channel B.
  • Alarm Priority: Displays the event messages of the card, i.e., special messages generated asynchronously on the card.
Note

If the setting of a parameter depends on another parameter, when the user tries to set the second parameter before the first parameter is set, a pop-up window will be displayed indicating what to do first. In this case, the user must set the first parameter according to the information in the pop-up window before setting the second parameter. For example, in order to set Coring Level (on the Down Converter pages), the Coring has to be set to Level_dep.

DataMiner Connectivity Framework

The 1.0.0.x connector range of the Axon ACP 2HS10 connector supports the usage of DCF.

DCF can also be implemented through the DataMiner DCF user interface and through DataMiner third-party connectors (for instance a manager).

Interfaces

Fixed interfaces

Physical fixed interfaces:

  • SDI Input A: A single fixed interface of type in
  • SDI Input B: A single fixed interface of type in.
  • SDI HD/SD Output A: A single fixed interface of type out.
  • SDI Output A: A single fixed interface of type out.
  • SDI HD/SD Output B: A single fixed interface of type out.
  • SDI Output B: A single fixed interface of type out.

Connections

Internal Connections

  • SDI Input A -> HD/SD SDI Output A
  • SDI Input A -> SDI Output A
  • SDI Input B -> HD/SD SDI Output B
  • SDI Input B -> SDI Output B
Improve this page