Axon ACP ERS10 - 2IX08

The 2IX08 is a dual-channel basic signal integrity monitor with switch-over function. The difference with the 2IX09 and 2IX10 is that these have an enhanced range of probing functions and 2 built-in frame synchronizers for clean switching. The switch function can be triggered by any of the integrity controls or by GPI. Each output has a fan-out of 3 and all outputs can be sourced from the same input.

The Axon ACP ERS10 - 2IX08 connector can be used to display and configure information of the related device.

About

A serial connection is used in order to successfully retrieve and configure the device's information. There are also different possibilities available for alarm monitoring and trending.

This connector is automatically generated by the connector Axon ACP ERS10.

Product Info

The table below indicates which device revision is available since a specific connector version. Every connector version, within the same range, also supports the previously implemented revisions.

Connector Version	Device Revision
1.0.0.1	Rev. 24
1.0.1.1	Rev. 24
1.2.0.1	Rev. 24
2.1.0.1	Rev. 24
2.2.0.1	Rev. 24

Installation and configuration

Creation

This connector is used by DVEs that are automatically created by the parent element. No user input is required.

Usage

General

This page contains generic information: Card Name, Slot Number, Card ID, Software Revision, Hardware Revision, etc.

Status

This page provides an overview of the card's status information: Reference, Carrier, EDH, etc.

Settings

This page provides an overview of the card's configuration settings: Input Selection, Carrier Detection, GPI Mode, etc.

Alarm Priority

This page contains the individual priority settings for the supported events.