Axon ACP SLD100
The SLD100 is a long time SD-SDI uncompressed baseband video delay unit. It can store and delay SD material, including all blanking, as RAW data.
The Axon ACP SLD100 connector can be used to display and configure information related to this device.
About
This connector can be automatically generated by the connector Axon ACP.
There are different possibilities available for alarm monitoring and trending.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version [SLC Main] | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1512 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | Yes | Yes | - | - |
Installation and configuration
Creation
This element can be automatically created by the element using the Axon ACP Frame Manager connector, but can also be used as a standalone connector.
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- Bus address: The bus address of the device, being the slot number of the card.
Serial Broadcast Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- Bus address: The bus address of the device.
Usage
This element has the following data pages:
- General: This page displays general information about the card: Card Name, Card Description, SW Revision, HW Revision, etc.
- SSD
- Status
- GPIO
- Marker
- Settings
- Network
- Alarm Priority: This page displays the event messages of the card, i.e., special messages generated asynchronously on the card.
DataMiner Connectivity Framework
The Axon ACP connector supports the usage of DCF.
DCF can also be implemented through the DataMiner DCF user interface and through DataMiner third-party connectors (for instance a manager).
Interfaces
Physical Interfaces
- Input SDI 1: A single fixed interface of type input.
- Input SDI 2: A single fixed interface of type input.
- Output SDI 1: A single fixed interface of type output.
- Output SDI 2: A single fixed interface of type output.
Connections
Internal Connections
- Between Input SDI 1 and Output SDI 1.
- Between Input SDI 1 and Output SDI 2.
- Between Input SDI 2 and Output SDI 1.
- Between Input SDI 2 and Output SDI 2.
Depending on the state of the Input Selection, the following connections are established:
0:
Between Input SDI 1 and Output SDI 1.
- Between Input SDI 1 and Output SDI 2.
1:
Between Input SDI 2 and Output SDI 1.
- Between Input SDI 2 and Output SDI 2.