Axon ACP U4D100
The U4D100 is a 4K (3840x2180) to 1080p, 4-wire down-converter. The low-latency unit combines and filters the four quadrants into a 1080p (1920x1080) signal.
The Axon ACP U4D100 connector is used to monitor status information and configure control parameters of the U4D100 card.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | 1014 1215 1316 1417 1418 1619 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (fixed value: 2071).
- Bus address: The bus address or slot number/position of the card in the frame.
Serial IP Connection - Events Connection
This connector uses a smart-serial connection and requires the following input during element creation:
SMART-SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination (fixed value: 2071).
- Bus address: The bus address or slot number/position of the card in the frame.
How to use
The element has the following pages:
- General: This page displays general information about the card: Card Name, Card Description, SW Revision, HW Revision, etc.
- Status: This page displays signal input, IO delay and reference status information.
- I/O: This page contains input/output control parameters that are used to configure the I/O settings of the card.
- Video: This page contains Gain and Black control parameters. These parameters are available for firmware versions 1417 and above.
- Settings: This page contains control parameters other than I/O and Gain such as the Lock Mode, Reference Type, etc.
- Alarm Priority: This page displays the event messages of the card, i.e., special messages generated asynchronously on the card.