Table of Contents

Axon ASM10

The Axon ASM10 is an Analog-to-Digital A/V Bridge with SDI plus embedded audio processing mode. This connector monitors and controls the device via SNMP.

About

The connector polls the device every 30 seconds for fast-varying information and every 6 minutes for slower-varying information. The collected information is then used to update the user interface.

Creation

The connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device.
  • Device address: A logical index, between 0 and 18.

SNMP Settings:

  • Port number: The port of the connected device, by default 161.
  • Get community string: The community string used when reading values from the device. The default value is public
  • Set community string: The community string used when setting values on the device. The default value is private

Usage

This connector has five pages: Main View, General Info, Settings_1, Settings_2, and Events.

Main View Page

On this page, the following general information is displayed:

  • SDI Input status
  • Analog Input status
  • Error Detection Handling (EDH) status
  • Ancilliary (ANC) status
  • Group Insert status
  • Embedded Audio 1-4 status
  • Analog Audio 1-4 status
  • Card Name
  • User Label
  • Description
  • Software Revision
  • Hardware Revision
  • Product Code
  • Serial Number
  • Card ID

General Info Page

On this page, the following parameters are displayed:

  • SDI Input status
  • Error Detection Handling (EDH) status
  • Ancillary (ANC) status
  • Card Name
  • User Label: the only configurable parameter.
  • Description
  • Software Revision
  • Hardware Revision
  • Product Code
  • Serial Number
  • Card ID

In addition, you can also find the following parameters below:

  • Analog Input status
  • Reference
  • Detected Format (Format DET)
  • Groups in Use status
  • Group Insert
  • Embedded Audio 1-4 status
  • Analog Audio 1-4 status

Settings_1 Page

For each input, the following configurable settings are displayed in the left column of this page:

  • Input Selection
  • Digital Standard
  • Analog Standard
  • NTSC Standard
  • PAL Standard
  • Synchronization Mode
  • Dynamic Noise Reduction (DNR)
  • Input Gain
  • Analog Input Level
  • Input Reference (Ref Input)
  • Freeze capture
  • Freeze Mode
  • Input-Loss
  • Delay

In addition, the following parameters are displayed in the right column:

  • Audio Out
  • Embedded Mode
  • Emb-B Mode
  • Emb-A Selection
  • Emb-B Selection
  • Tracking Type
  • VLI Insert
  • WSS Insert
  • WSS Extended Insert
  • WSS Standard Insert
  • Blank-V-ANC status
  • EDH Detection
  • EDH Generator

Settings_2 Page

For each input, the following configurable settings are displayed in the left column:

  • Audio Phase Channel 1-4
  • De-embedded (De-emb) Channel 1-4
  • Analog Channel 1-4 Input
  • Audio Gain Channel 1-4
  • Y/C Gains
  • Y-Black/C-Black level
  • H/V-Delay
  • Y-Shaping
  • Y-Peaking

Events Page

On this page, the following alarm priorities can be defined:

  • Announcements
  • Input SDI Priority
  • Input ANA Priority
  • EDH Status Priority
  • Reference Status Priority
  • ANC Status Priority

Notes

Version 1.0.1.1 is based on version 1.0.0.8, with additional DCF functionality.

Improve this page