Axon SDB15

This connector is used to monitor the Axon SDB15 Audio Embedder.

About

This connector uses SNMP in order to display information and configure settings of the device.

Installation and configuration

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device.
• Device address: Required address: 1, 2, 3 and 12.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string in order to read from the device. The default value is public.
• Set community string: The community string in order to set to the device. The default value is private.

Usage

The Axon SDB15 connector has the following pages: Main View, General Info, Settings and Events.

Main View / General Info

This page displays the information status of SDI Input, FPGA, EDH, ANC, Audio Embedders and Channels. It also contains information about the device itself, such as the Card Name and ID, Description, Software and Hardware Revision, Product Code and Serial Number.

Settings

On this page, you can configure settings regarding the Output and Add-Ons Channels, Gains, Phases, Audio Out Levels and EDH Detection.

Events

On this page, you can configure Announcements, Input Prority, EDH Status Priority and ANC Status Priority.

Notes

DCF implementation on version 1.0.1.1.