Belgacom RTES Farm
With this connector it is possible to monitor multiple Verimatrix RTES Pairs.
About
The Belgacom RTES Farm monitors multiple redundant pairs of Verimatrix RTES Pair elements. It also monitors the connections with the selected CISCO Manager element.
Installation and configuration
Creation
The Belgacom RTES Farm is a virtual connector, so no user information is required during element creation.
Configuration
To select all the Verimatrix RTES Pairs that are to be monitored:
- Go to the General page.
- Click the Refresh RTES button.
- Select the desired RTES Pair in the drop-down list.
- Click the Add RTES button.
- Repeat steps 3 and 4 for all the RTES Pairs you want to add.
To configure the CISCO Manager:
- Go to the Switch page.
- Click the Refresh Discreets button.
- Select Primary and Backup Switches from the drop-down list.
- Select the primary and secondary ports from the Switches to access the main and backup router.
After configuring the Primary and Backup Switches on the RTES Status page, you can configure the switch ports for which each RTE Pair is to monitor the transmission and receiving bit rate.
Usage
General Page
On this page, you can configure which RTES Pairs are to be monitored by this farm (see "Configuration" section above).
RTES Status Page
This page displays a table with the error values and communication states of each monitored RTES Pair. A Farm Preference parameter is shown, which depends on these parameters.
The page also allows the user to configure to which Switch port the RTES devices are connected, and provides information about the transmission and receiving bit rate.
Switch Page
On this page, you can configure the CISCO Manager and choose which element represents the primary and backup switches (see "Configuration" section above). You can also select the primary and backup ports that connect the switch to the routers and have information about the transmission and receiving bit rate.