Benning MCU1000

This connector is used to monitor the MCU1000 device.

About

All the status information is retrieved via a serial command. Then appropriate parameters are updated and meaningful alarms are generated.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• IP address/host: The polling IP of the device, e.g., 192.168.1.2.
• IP port: The IP port of the device, e.g., 80.
• Bus address: Not required.

Usage

Main View

On this page, the main alarms and the most important electrical quantities are displayed.

For the alarms you can amongst others find the following parameters: Urgent Alarm, Non-Urgent Alarm , Rectifier x Failure, ...

For the electrical quantities, you can for example find the following parameters: Busbar Voltage, Total Rectifier Current, Maximum Load Power, ...

General

This page contains general system information, such as the Serial Number, Date, and Time. You can also find more detailed electrical data here: Busbar Voltage, Load Current Total, Rectifier Currents (via the Detailed Info page button).

Alarm

All the alarms are grouped on this page, with amongst others the following information: Battery Fuse, Non-Urgent Alarm, Modem Status, Discharging Battery, Rectifier x Failure, Mains Error Rectifier x, Fan Rectifier x Failure, ...