Benning MCU 3000
This connector is used to monitor the Benning MCU 3000 UPS system.
All the status information is retrieved via a serial command. The appropriate parameters are updated, and meaningful alarms are generated.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | - |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device. e.g., 192.168.1.2.
- IP port: The IP port of the device. e.g., 4006.
- Bus address: Not required.
Initialization
When the timeout of a single command is set to a short duration, it can occur that not all response data is received. Configure the settings below when you configure the element to allow full polling of the device response:
- Timeout of a single command: 5000
- Number of retries: 3
How to Use
General
This page contains general system information, such as the Serial Number, Date, Time, etc.
You can also find more detailed electrical data here, as well as an overview of the Rectifier Current.
The Voltage subpage displays all parameters related to voltage, and the Current subpage displays all parameters related to current and power.
Alarms
All the alarms are grouped on this page, with information such as Load Fuse, Non-Urgent Alarm, Modem Status, etc.
Via page buttons, you can access the Voltage Alarms, Status Alarms, and Battery Alarms subpages, which contain more specific alarm parameters.