Blackmagic Design HyperDeck
The Blackmagic Design HyperDeck disk recorders let you record the highest quality uncompressed or compressed ProRes and DNxHD video formats using fast 2.5" SSDs.
About
This connector communicates with the device using serial commands as described in the device's manual. For more information please refer to the website https://www.blackmagicdesign.com/products/hyperdeckstudio
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 1.3 |
Installation and configuration
Creation
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- Type of Port: TCP/IP
- IP address/host: The polling IP of the device, e.g., 10.11.12.13.
- IP port: The IP port of the device, by default 9993*.*
- Bus address: Not used*.*
Usage
General
This page displays general information from the deck.
Settings
On this page it's possible to change some of the Remote Control, Notification and Configuration settings of the deck.
Slots
Page shows the two available slots and its status.
Clips
This page can be used to control the clips available in each one of the slot disks.
Debug
Page available to send manually commands to the deck. a pre-defined list of the available commands is already available.