Brandywine Communications NFS-220

The Brandywine Communications NFS-220 connector monitors and controls the unit through SNMP.

About

The connector polls relevant information from the device every 10 seconds, every 10 minutes or every hour.

Creation

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

• IP address/host: The polling IP of the device.

SNMP Settings:

• Port number: The port of the connected device, by default 161.
• Get community string: The community string used when reading values from the device. The default value is public.
• Set community string: The community string used when setting values on the device. The default value is private.

Usage

This connector has several data display pages:

General Page

This page displays the Product Name, Serial Number, Version, Date, IP Address, Gateway Sub Net and DHCP.

The page also has two buttons to Save Device Config to non volatile memory (will be remembered upon restart) and to do a Soft Reset of the device.

Status Page

This page displays the alarms and faults of the device, as well as the number of tracked satellites, its position and velocity.

Time Page

This page displays information regarding the configured Timezone on the left and the Serial Baud Rate on the right.

Reference Page

This page displays configurable information regarding the output levels of the 10Mhz, the Delay of the 1PPS, the PPS Width among others.

Web Interface Page

This page displays the web interface of the device. The client machine has to be able to access the device. If not, it will not be possible to open the web interface.