Bry Air FFB-170
The Bry Air FFB-170 dehumidifiers offer solutions to humidity control problems and can maintain RH as low as 1% or even lower at a constant level, regardless of ambient conditions.
This connector uses MODBUS communication to monitor the dehumidifiers.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | FFB-170 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Modbus Communication
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Direct connection:
- Baudrate: Baudrate specified in the manual of the device, e.g., 9600 (default: 19200).
- Databits: Databits specified in the manual of the device, e.g., 7 (default: 8).
- Stopbits: Stopbits specified in the manual of the device, e.g., 1 (default: 2).
- Parity: Parity specified in the manual of the device, e.g., No (default: no).
- FlowControl: FlowControl specified in the manual of the device, e.g., No.
Interface connection:
- IP address/host: The polling IP or URL of the destination.
- IP port: The IP port of the destination.
- Bus address: The bus address of the device (default: 1).
How to use
You can find all the information you need to monitor the device on the General data page.