C-COR CHP 2RRX

This connector is automatically generated by the connector C-COR CHP SMM, version 2.0.0.x. It is an SNMP-based connector that is used to monitor and configure the C-COR CHP 2RRX.

About

This connector provides a monitoring interface for the C-COR CHP 2RRX chassis.

Product Info

Range	Supported Firmware Version
2.0.0.x	Boot v001.000

Installation and configuration

Creation

This connector is used by DVE child elements that are automatically created by the parent connector C-COR CHP SMM.

Usage

General

This page contains general information about the card, such as the Physical State, Reset Cause, Mode of Operation, Local Control, Module State and Internal Temperature.

There are also two page buttons:

• Device Info: Displays the parameters Module, Module Name, Serial Number, Hardware, Firmware, Bootdown, etc.
• Internal Threshold: Allows you to configure both Major (High and Low) and Minor (High and Low) thresholds for Input Power A and B and for Internal Temperature.

Optical

This page displays the Optical Power, Control, Wavelength and Optical Status for A and B receivers.

The Normalize page button opens a subpage where the Optical Power A and B can be normalized.

RF

This page displays the Output State, Channel Control, Low Attenuation and Total Attenuation for A and B receivers.