C-COR CHP FTX

The C-COR CHP FTX connector is an SNMP-based connector that can be used to monitor and configure the C-COR CHP FTX.

About

This connector provides a monitoring interface for the C-COR CHP FTX chassis. It is automatically generated by the parent connector C-COR CHP SMM.

Product Info

Range	Supported Firmware Version
2.0.0.x	Boot v001.003

Installation and configuration

Creation

This connector is used by DVEs that are automatically created by the parent element. No user input is required.

Usage

General

This page displays general information about the card: Physical State, Reset Cause, Mode of Operation, Local Control, Module State and Internal Temperature.

It also displays the following device info: Module, Module Name, Serial Number, Hardware, Firmware and Bootdown.

Finally, it also displays the internal thresholds for Optical Output Power, Drive Control, Bias Current, Internal Temperature and Laser Temperature.

Optical

This page shows the following parameters: Laser Type, Laser Shutdown Cause, Laser Wavelength, Laser Button, LAser Status, Filter Slope, Fiber Length, Laser Bias Current, Laser Temperature and Laser Power.

RF

This page displays the parameters RF Gain, Laser Drive Ratio, AGC Mode and RF Present.