Table of Contents

CEFD CDM-570A Serial (FSK)

The CDM-570A Serial (FSK) is a DVE connector. It will show Comtech EF Data's external connected Block Upconverters (BUCs) and Low-Noise Block Downconverters (LNBs) values.

About

This connector is intended to communicate with CDM-570A devices using serial commands as described in the device manual.

Note: This connector is automatically generated by connector CEFD CDM 570A Serial.

Supported firmware versions

Range Supported Firmware Version
1.0.0.x -

Installation and configuration

Creation

Serial Main connection This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

  • Interface connection:

    • IP address/host: The polling IP of the device
    • IP port: The IP port of the device.
    • Bus address: The bus address of the device.

Usage

BUC

Use this page to configure Block Up Converter parameters and to check BUC status for L-Band operation.

LNB

Use this page to configure Low-Noise Block Down Converter parameters and to check LNB status for L-Band operation.

Improve this page