CEFD CDM-570 Serial (FSK)
The CDM-570 Serial (FSK) is a DVE connector. It will show Comtech EF Data's external connected Block Upconverters (BUCs) and Low-Noise Block Downconverters (LNBs) values.
About
This connector is intended to communicate with CDM-570 devices using serial commands as described in the device manual.
Note: This connector is automatically generated by connector CEFD CDM 570 Serial.
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Boot:1.1.1 Bulk1:1.6.16 Bulk2:1.6.16 |
| 2.0.0.x | Boot:1.1.1 Bulk1:1.6.16 Bulk2:1.6.16 |
| 3.0.0.x | Boot:1.1.1 Bulk1:1.6.16 Bulk2:1.6.16 |
Configuration
Connections
Serial Main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device.
- Bus address: The bus address of the device.
Usage
BUC
Use this page to configure Block Up Converter parameters and to check BUC status for L-Band operation.
- Use the provided toggle buttons to turn BUC DC Power Control, 10 MHz Reference, RF Output, and Communication to Enabled or Disabled.
- BUC Low and High Current Limit value ranging from 0 to 4000 mA.
- BUC Lockout Frequency from 3000 to 65000 MHz and designate the value as a HIGH (+) or LOW (-) limit.
- BUC Address from 0 to 15.
- BUC Status: The values displayed in this section are read-only and cannot be changed.
LNB
Use this page to configure Low-Noise Block Down Converter parameters and to check LNB status for L-Band operation.
- DC Supply Voltage: Off or On with 13, 18 or 24 V.
- LNB 10MHz Reference: Enable operations Disabled or Enabled.
- Assign LNB Current Lower and Current Upper Alarm Limit values ranging from 10 to 600 mA.
- Assign an Rx Lockout Frequency and designate the value as a HIGH (+) or LOW (-) limit.
- LNB Status: The LNB Current and LNB Voltage values displayed in this section are read-only and cannot be changed.