CEFD CDM-625 Serial
The CDM-625 Serial Advanced Satellite Modem is intended for both closed network and legacy Intelsat applications. The CDM-625 is a replacement for the CDM-600 and CDM-600L Open Network Satellite Modems.
To further information access the link http://www.comtechefdata.com/support/docs/satellitemodemdocs.
About
This connector is intended to get and set information in the device via an Element in a DataMiner System, using Serial commands.
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
| 2.0.0.x | - | - | - |
| 3.0.0.x | - | - | - |
| 3.0.1.x | Multiple tables now uses naming instead of displayColumn to make the database for these tables Cassandra-compliant. | 3.0.0.16 | Old trend data will be lost for these tables. |
| 4.0.0.x | - | - | - |
Installation and configuration
Creation
SERIAL CONNECTION
- Type of Port: the type of port used to connect to the device, default TCP/IP
- IP address/host: the polling IP of the Ethernet To Serial Converter eg 10.11.12.13
- IP Port: the port addressed to connect the device, set in the Ethernet To Serial Converter, eg 4001
- BUS Address: the BUS address set in the device, eg 1
Usage
General
This page contains information about the system and about the overall status of the device.
Admin-Firmware
On this page, you can set the Base Modem and Packet Processor Firmware versions.
Admin - FAST
This page provides information about the Equipment ID and the installed Hardware.
Config - Modem
On this page, you can set the modem's Transmit and Receive parameters. Via page buttons, you can also access the configuration for the ACM and CnC parameters.
Config - LAN - IP
Network Configuration, Per Port Configuration, VLAN Mode and related parameters can be set here.
Config - Overhead
Access this page to configure ESC, AUPC and EDMAC. Via the page buttons, you can set CnC-APC and IDR Backward Alarms.
Config - Utilities
Parameters related to Redundancy, Buffer, Unit, Clocks, Circuit ID, Date & Time, BERT Config, Warm-Up, and Save/Load Configuration can be found here.
Config - Drop and Insert
On this page, you can configure Drop and Insert and Quad Drop and Insert settings.
Config - BUC / LNB
On this page you can set the BUC and LNB Configuration and also its Status.
Config - PTP
The PTP feature can be configured on this page.
Status - Modem Status
Here you can get the status of the modem's functionalities. Those can be the Alarms, Rx Parameters, CnC, General Status, AUPC, WAN Statistics, ACM Status, and Fractional CnC Counters.
Status - Modem Logs
To get information about latest Events and device Statistics, use this page. This can be enabled or disabled through the buttons. Initialize Pointer is used to load from the device's memory again when polling is disabled. To mask alarms, use the Alarm Masking page button.
ODU / Redundancy
On this page you can configure settings related to the Outdoor Unit and Redundancy.
FSK
on this page you can set the FSK functionality. This functionality will generate a virtual element that contains all BUC/LNB parameters. A unique FSK Element Name can be set for the virtual element.
Save / Load Configuration
On this page you can save all parameter values to a CSV file. You can also load such a CSV file to set the parameters to the saved values.
By default, the file is stored in this folder: C:\Skyline DataMiner\Documents\DMA_COMMON_DOCUMENTS\PROTOCOLNAME]
By default, the file is name backup_ELEMENTNAME_datetime