CEFD CDM 750
Advanced High-Speed Trunking Modem for network operators, enterprise users, and service providers requiring maximum throughput while using minimal satellite resources in point-to-point links. The CDM750 combines DVB-S2 modulation and coding with Comtech's DoubleTalkT Carrier-in-Carrierr and throughput maximizing Adaptive Coding and Modulation (ACM) technologies to optimize high speed satellite data links.
About
This connector uses SNMP to retrieve information from the device and configure settings on the device.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 1.6.6 |
Installation and configuration
Creation
SNMP Main Connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- IP port: The IP port of the device.
- Get community string: The community string used when reading values from the device, by default public
- Set community string: The community string used when setting values on the device, by default private
Usage
General
This page displays general information about the device.
Admin - SNMP
This page contains SNMP information, such as the Contact, Name, Location, Trap IP, etc.
Config - Modem
This page contains modem configuration settings for DVB-S2 Transmit/Receive frames, DoubleTalkT Carrier-in-Carrier and Adaptive Coding and Modulation (ACM).
Config - Utilities
This page contains the Date & Time, Clock frequency, Redundancy Control and Firmware Image settings.
Config - Test
This page contains Test Mode configurations.
Config - LNB
This page contains Low-Noise Block Down Converter (LNB) configurations.
Status
On this page, you can find status information regarding Alarms, ACM, CnC, Receiver parameters and Redundancy switch.
Status - Logs
This page contains an events log in the Events Overview table, along with the corresponding Alarm Settings.
Status - Info
This page displays general status information.
Status - IP Statistics
This page displays IP sent/received packets statistics.
Status - BB Statistics
This page displays Baseband framing statistics.
Interfaces - Ethernet/PIIC
On this page, you can find the OC3 and G.703 interfaces configurations table.
Web Interface
This page displays the web interface of the device. Note that the client machine has to be able to access the device, as otherwise it will not be possible to open the web interface.