Table of Contents

CEFD H SNMP - FSK

The CEFD H SNMP - FSK connector is used by virtual elements created by the CEFD H SNMP connector. It displays information on the FSK functionality of the CEFD H SNMP connector.

NOTE: In the ranges 1.x.x.x and 2.0.0.x, the created DVE protocol is called CEFD H SNMP (FSK) instead.

About

This connector is exported by the CEFD H SNMP connector. It provides information on the FSK functionality and allows the user to monitor and control BUC and LNB components.

Product Info

Range Supported Firmware Version
1.0.0.x Unknown
1.1.0.x 2.4.1
1.2.0.x 2.6.1
2.0.0.x 2.6.1
2.0.1.x 2.6.1

Installation and configuration

Creation

In order to generate the DVE using this connector, enter the FSK Element Name on the FSK page of the CEFD H SNMP connector, ranges 1.1.0.x, 1.2.0.x, 2.0.0.x and 2.0.1.x.

Usage

BUC

This page contains the following BUC parameters:

  • BUC Power Supply: Allows you to enable or disable the BUC power control.
  • BUC 10Mhz Reference State: Allows you to enable or disable the reference.
  • BUC Low Current Limit: Allows you to set the BUC minimum threshold current.
  • BUC High Current Limit: Allows you to set the BUC maximum threshold current.
  • BUC FSK Communications: Allows you to enable or disable FSK communication.
  • BUC FSK Address: Allows you to specify a BUC address as a value between 1 and 15.
  • BUC RF Output: Allows you to enable or disable Tx carrier output power.
  • BUC Attenuation: Allows you to set the attenuation level in dB.
  • BUC Power Supply Option: Indicates if the BUC Power Supply Option has been installed.
  • BUC Voltage: Displays the BUC voltage in V.
  • BUC Current: Displays the BUC current in mA.
  • BUC Temperature: Displays the BUC temperature in degrees Celsius.
  • BUC Phase Lock Loop: Only valid when FSK/BUC is turned on.
  • BUC Power Level: Displays the BUC output power level.
  • BUC Power Class: Displays the BUC power class in Watts.
  • BUC Software Version: Displays the BUC software version.
  • BUC LO Frequency: Allows you to set the BUC local oscillator frequency (range: 3000 - 65000 MHz).
  • BUC LO Mix: Determines whether the L-Band carrier is added or subtracted from the LO.
  • BUC Tx RF Frequency: Displays the BUC Tx satellite frequency.

LNB

This page contains the following LNB parameters:

  • LNB DC Power: Allows you to enable or disable the LNB power control.
  • LNB Reference State: Allows you to enable or disable the reference.
  • LNB Current Low Threshold: Allows you to set the LNB minimum threshold current.
  • LNB Current High Threshold: Allows you to set the LNB maximum threshold current.
  • LNB Current: Displays the LNB current in mA.
  • LNB Voltage: Displays the LNB voltage in V.
  • LNB LO Frequency: Allows you to set the receiver local oscillator frequency.
  • LNB LO Mix: Determines whether the L-Band carrier is added or subtracted from the LO.
  • LNB Rx RF Frequency: Displays the terminal receiver frequency.
Improve this page