CEFD LBC-4000 SNMP
With this connector it is possible to monitor CEFD LBC-4000 devices with SNMP.
About
The CEFD LBC-4000 SNMP will monitor the CEFD LBC-4000 device.
Installation and configuration
Creation
The CEFD LBC-4000 SNMP is an SNMP connector. The IP needs to be configured during creation of the element.
SNMP CONNECTION:
- IP address/host: The polling IP of the device, e.g., 10.11.12.13
SNMP Settings:
- Port number: the port of the connected device, default 161
- Get community string: the community string in order to read from the device. The default value is public.
- Set community string: the community string in order to set to the device. The default value is private.
Usage
General Page
This page displays some general info of the device:
- Model Number
- Serial Number
- Software Revision
- ...
Converters Page
In this page we display parameters from the A nad B converters.
Event Log Page
In this page we display the Event Log table.
Remote Control Page
In this page we display the values referent to Serial and SNMP interfaces.
Redundancy Page
In this page we display the values referent to the Redundancy.
Monitors Page
In this page we display the Voltages and temperatures of both converters.
Summary Page
In this page we display the alarm statuses.
Firmware Page
In this page we display a table with the firmware available on the device.
Faults Page
In this page we display a table with the faults detected on the device.
Web Interface Page
In this page we display the web interface of the device.