Table of Contents

CEFD Memotec Netperformer SDM8400

The Memotec Netperformer SDM8400 version is an SNMP connector intended to communicate with SDM8400 Netperformer devices.

About

An SNMP connection is used in order to successfully retrieve and configure the device's information.

Configuration

Connections

SNMP Connection - Main

This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:

SNMP CONNECTION:

  • IP address/host: The polling IP of the device.

SNMP Settings:

  • IP port: The IP port of the device.
  • Get community string: The community string used when reading values from the device (default: public).
  • Set community string: The community string used when setting values on the device (default: public).

How to Use

Here is some general info about the unit.

Configuration - Global

All the global parameters available for configuration are shown here. Also, the following pages are provided with extra settings:

  • Extra
  • Rackmount Chassis

Configuration - Advanced

All redundancy-related parameters are available on the following subpages:

  • Redundancy Criteria
  • Redundancy Remote
  • Redundancy Switch

Configuration - Others

This page provides an overview of some general configurations of the Netperformer unit.

Configuration - IP

This page provides access to all the different configuration profiles available on the Netperformer unit for IP Configuration:

  • BOOTP
  • DNS
  • Global IP
  • NAT
  • OSPF
  • RADIUS
  • SNMP
  • Source-Static
  • Static
  • TimeP
  • Interfaces

Configuration - Slots Link

The Configuration - Slots Link page gives an overview of all defined links on te Netperformer unit.

Configuration - Slots Channels

  • VCE/WAN Table provides an overview of all available Slots Channels on the Netperformer unit and it's configured Protocol and Timeslot.
  • For each available protocol, there's a page available which provides an overview of all related slots channels.

Configuration - Ports

This page provides the Netperformer base unit ports. In Port CSL and Port 1 page buttons after selecting which protocol should be used you must go to the respective protocol page button. Some parameters will be only available if the respective option is active. Otherwise the parameter will be assigned with Not-Configured.

Configuration - PVC

  • PVC Table provides an overview of all available Modes on the Netperformer unit.
  • For each available mode, there's a page available which provides an overview.

Alarms

The Alarms menu shows all current alarms. Clear Alarms and Clear Error LEDs buttons are available to clear them.

Counters

The Counters menu provides access to a selection of counters for the current unit. The Reset Counters button resets all counters.

Errors

The Errors page lets you have access to various types of errors.

States

This page provides an overview of all various types of states:

  • States LDC
  • States Redundancy
  • States Port Eth
  • States Port CSL
  • States Port 1-304

Routing Table

The Netperformer Routing provides access to various Routing Table selections.

Web Interface

Use this page to have access to the Web Interface provided by the device's web server. The web interface is only accessible when the client machine has network access to the product.

Improve this page