CEFD xSAT-5060 Serial

The xSAT-5060 Serial is designed for use in communication systems, or in satellite uplink data systems, for the reception of SCPC/MCPC, DAMA, and TDMA communication signals. It also can be used in communications system applications with full transponder HDTV and analog TV.

To further information access the link http://www.comtechefdata.com/support/docs/transceiverdocs.

About

This connector is intended to get and set information in the device via an Element in a DataMiner System, using Serial commands.

Installation and configuration

Creation

SERIAL CONNECTION

• Type of Port: the type of port used to connect to the device, default TCP/IP
• IP address/host: the polling IP of the Ethernet To Serial Converter eg 10.11.12.13
• IP Port: the port addressed to connect the device, set in the Ethernet To Serial Converter, eg 4001
• BUS Address: the BUS address set in the device, eg 1

Usage

General Page

Use this page to configure Tx and Rx parameters. Some other device functions are present here.

Configuration Status

Device Status and Information can be accessed here. Date/Time and Communication configurations can be done in this page.

LNA Status

To configure and calibrate the LNA use this page.

Redundancy Status

Redundancy configuration and Status can be accessed here.

Maintenance Status

Use this page to have a broad overview over device's measurements.

Alarm Status

All about device alarms can be consulted here.