CISCO Unified Communications Manager
This connector can be used to monitor the CISCO Unified Communications Manager. The CUCM is responsible for the management and configuration of SIP and VoIP lines and extensions.
About
This is a read-only SNMP monitoring connector, which polls information about registered devices and the local CUCM cluster connection status.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x [SLC Main] | Initial version | No | Yes |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | 11.5.1.12900-21 |
Installation and configuration
Creation
SNMP Main connection
This connector uses a Simple Network Management Protocol (SNMP) connection and requires the following input during element creation:
SNMP CONNECTION:
- IP address/host: The polling IP of the device.
SNMP Settings:
- Port number: The port of the connected device, by default 161.
- Get community string: The community string used when reading values from the device, by default public.
- Set community string: The community string used when setting values on the device, by default private.
Usage
General
This page displays general parameters related to the device. It also contains the CUCM Cluster Table, which contains information on all the known CUCMs in a CUCM cluster.
Phones
This page displays the Phone Table, which lists all phone devices that have tried to register with the local CUCM at least once.
Note: This table may be exceptionally large, so polling may take around 3 minutes.
Gateways
This page displays the Gateway Table, which lists all gateway devices that have tried to register with the local CUCM at least once.
Media Devices
This page displays the Media Devices Table, which lists all media devices that have tried to register with the local CUCM at least once.
CTI Devices
This page displays the CTI Devices Table, which lists all CTI (Computer Telephony Integration) devices that have tried to register with the local CUCM at least once.