Table of Contents

CPI 01032330-01

The CPI 01032330-01 connector is a serial connector used to monitor and configure the CPI 01032330-01 switch.

About

The CPI 01032330-01 connector is a serial connector. It can be used to configure the W/G Switch 1 - 4 positions. It also allows the monitoring of some faults and other settings.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

  • IP address/host: The polling IP of the device, e.g., 10.11.12.13.
  • IP port: The port of the connected device.
  • Bus address: The bus address of the connected device. (Between 48 and 111.)

Usage

General

The General page is the only page that displays parameters in the connector. It displays the W/G Switch Controller Mode as well as the W/G Switch 1 - 4 positions. It also displays the Switch System and the faults. These faults are AMP Fault, Fault Recycled and AUX Faults (WGS 2 - 4).

Web interface

This displays the web interface of the CPI 01032330-01 switch.

Improve this page