Table of Contents

CPI 01039168-00

The CPI 01039168-00 connector is a serial connector used to monitor and configure the CPI 01039168-00.

About

The CPI 01039168-00 connector is a serial connector that displays information about HPAs and switches.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

  • IP address/host: The polling IP of the device, e.g., 10.11.12.13.
  • IP port: The port of the connected device.
  • Bus address: The bus address of the connected device. (Between 48 and 111.)

Usage

General

The General page is the only page in the connector. It displays switch and HPA information, a well as the switch position for W/G switch 1, 2 and 3. The page also displays the alarm state for HPA 1, 2, 3 and 4. It also allows changes of the amplifiers' priority.

Improve this page