CPI 4715430-01
This connector can be used to monitor and configure a CPI 4715430-01 ACU (Antenna Control Unit) device.
The connector uses UDP communication. SFTP and SSH are also used to retrieve some parameters and to download files from the device.
About
Version Info
| Range | Key Features | Based on | System Impact |
|---|---|---|---|
| 1.0.0.x | Initial version | - | - |
Product Info
| Range | Supported Firmware |
|---|---|
| 1.0.0.x | Software version: 3.10.17.54 |
System Info
| Range | DCF Integration | Cassandra Compliant | Linked Components | Exported Components |
|---|---|---|---|---|
| 1.0.0.x | No | Yes | - | - |
Configuration
Connections
Serial Main Connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
Interface connection:
- IP address/host: The polling IP of the device.
- IP port: The IP port of the device, by default: 4143.
Initialization
This connector uses the SFTP and SSH protocols to retrieve some parameters. For this purpose, the Renci.SshNet.dll file must be present on the DMA.
In addition, to be able to use those protocols, you must fill in the SSH Username and SSH Password on the SSH page.
How to Use
Parameters on the General, Status and Faults pages are retrieved using the UDP protocol.
Parameters on the Config and Files pages are retrieved using the SFTP and SSH protocols.