Table of Contents

CPI K4U64

With this connector, you can monitor a CPI K4U64 amplifier.

About

The CPI K4U64 connector uses a serial connection in order to monitor and configure a CPI K4U64 1:2 LNA protection switch.

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

  • IP address/host: The polling IP of the device, e.g., 10.11.12.13.
  • IP port: The port of the connected device.
  • Bus address: The bus address of the connected device's relay processor, ranging from 33 up to and including 126.

Usage

General Page

This page displays general information regarding the device:

  • Device Time and Date
  • Software Versions

Configurations Page

This page displays configurable parameters, like the transmit mode or the RF Inhibitor state.

Faults Page

This page displays fault statuses of the device.

Status Page

This page displays the current, voltage and temperature alarm status.

Measurements Page

This page displays the values for the current, voltage, humidity and temperature.

Improve this page