CPI TL05KO

The CPI TL05KO is a Outdoor 500W Power Unit designed for wideband single- and multi-carrier satellite services over 600 MHz over the reverse Ka-band frequency band.

About

This connector is intended to communicate with the device using serial commands as described in the device's manual. More information: http://www.cpii.com/product.cfm/4/15/256

Installation and configuration

Creation

This connector uses a serial connection and requires the following input during element creation:

SERIAL CONNECTION:

• Type of Port: TCP/IP
• IP address/host: e.g., 10.11.12.13
• IP port: eg. 10039
• Bus address*:* 48

Usage

General

In this page is available general information about the device. Use the Inhibit page button to get the inhibit parameters.

Measurements

Several measurement points of the device are shown here.

Switch Controller

On this page are available the parameters that control the Switch's position and priority.

Switch System Status

This page shows the status of the switch.

Settings

It's possible to set the Time of the device. Use the Set Time page button for that purpose. It's also available, on this page, switch related settings.

Alarms

All alarms related to the device are shown here. Rover over the page buttons to get the alarms related to each component of the device.