CPI TL12DO
The CPI TL12DO is a 1.2 kW "SuperLinear" outdoor TWT amplifier designed for satellite uplink applications.
About
This connector is intended to communicate with the device using serial commands as described in the manual of the device. For more information, see https://www.cpii.com/product.cfm/4/15/255.
Version Info
| Range | Description | DCF Integration | Cassandra Compliant |
|---|---|---|---|
| 1.0.0.x | Initial version | No | No |
Product Info
| Range | Supported Firmware Version |
|---|---|
| 1.0.0.x | Unknown |
Installation and configuration
Creation
Serial main connection
This connector uses a serial connection and requires the following input during element creation:
SERIAL CONNECTION:
- Type of Port: TCP/IP
- IP address/host: The polling IP of the device, e.g., 10.11.12.13.
- IP port: The port of the device, by default 50000.
- Bus address*:* The bus address of the device, by default 48.
Usage
General
This page contains general information on the device.
Via the Log page button, you can retrieve log entries for the device. To do so, set the Log Entry RF Units and then the Log Entry Number to Get. Retrieving the same entry number with a different unit will overwrite the row with the same entry number.
Measurements
This page displays several measurement points of the device.
Switch Controller
This page contains the parameters that control the switch position and priority.
Switch System Status
This page displays the status of the switch.
Settings
On this page, you can set the Amplifier Name as well as the Time of the device (via the Set Time page button).
The page also contains switch-related settings.
Alarms
This page displays all alarms related to the device. The page buttons provide access to the alarms related to each component of the device.
Web Interface
This page can be used to access the web interface of the device. However, note that the client machine needs to be able to access the device, as otherwise it will not be possible to open the web interface.